MKS GEN V1.4 3D Printer Control Motherboard combines and improves the assets solution of the RAMPS 1.4 and Arduino Mega 2560 board on a fantastic single board. 3D MKS Gen V1.4 printer motherboard control board is an optimal 3D printer controller solution for your Reprap 3D printer.

Features:

1. Can accept 24V input power under the same system can be hot-bed current is reduced to 1/4, an effective solution to the hotbed MOS pipe heat problems.
2. The firmware can use open-source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4.
3. Can be connected to the control panel and 12864LCD Ramps1.4,2004LCD control panel.(Cant be sure to match all of the types of 12864LCD and 2004LCD )
4. Reserved for the motor pulse and direction output ports for easy plug-in high-current To add a large current (eg 2A, 5A) motor drive circuit.
5. Reserved Ramps1.4 on Servos, AUX-1, AUX-2 interface that provides three 5V output, three 12V outputs.
6. Mega 2560 and ramps1.4 set on a board, to solve complicated Ramps1.4 combination of interfaces, the problem of failure.
7. Supports to the 4988 and 8825 Motor driver.
8. The circuit board is a high-quality 4-layer board, with heat optimization
9. High-quality MOSFET, and better heat dissipation.
10. Dedicated power chip, support 12V-24V power input, the voltage converter chip to solve the heat problem Ramps.

Package Includes:

1 x MKS GEN V1.4 3D Printer Control Motherboard

1 x 50cm USB Cable

Specifications :-

Model	MKS Gen V1.4
Type	MKS Gen V1.4 control board Mega 2560
Cable length	30 cm
Length (mm)	140
Width (mm)	90
Height (mm)	15
Weight (gm)	93